<![CDATA[Color Sensor RGB Unit UI 1.3.2 (TCS3472) / R G B Data always on 0]]>

<![CDATA[Color Sensor RGB Unit UI 1.3.2 (TCS3472) / R G B Data always on 0]]>My sensor only shows me the RAW data.
The values of R G B (single) are always 0.

UI V1.3.2 / V 1.4.0

Contains a calibration table which is probably wrong:

values smaller than 0 must be set to zero
If the calibration table matches the integration time of 154 MS. The Arduino example assumes 50 MS.

3 The module reacts logarithmically. So it should not be approximated with a 3rd degree function !

Could this be checked?
I would like to make an instruction video on my Youtube channel (UI Flow),
but I can't get any further.

Alf

]]>https://community.m5stack.com/topic/1436/color-sensor-rgb-unit-ui-1-3-2-tcs3472-r-g-b-data-always-on-0RSS for NodeSun, 08 Mar 2026 02:57:14 GMTThu, 31 Oct 2019 08:51:46 GMT60<![CDATA[Reply to Color Sensor RGB Unit UI 1.3.2 (TCS3472) / R G B Data always on 0 on Thu, 31 Oct 2019 09:41:29 GMT]]>Contact me after 6pm GMT on Discord and I will see what I can do.

]]>https://community.m5stack.com/post/6227https://community.m5stack.com/post/6227Thu, 31 Oct 2019 09:41:29 GMT