<![CDATA[M5Paper error message]]>Hello,

When I upload an arduino program to M5Paper then there is the following message in the Arduino IDE:

esptool.py v3.0-dev
Serial port COM6
Connecting....
Chip is ESP32-D0WDQ6-V3 (revision 3)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: b8:f0:09:c6:29:10
Uploading stub...
Running stub...
Stub running...
Configuring flash size...
Warning: Could not auto-detect Flash size (FlashID=0xffffff, SizeID=0xff), defaulting to 4MB
Compressed 8192 bytes to 47...
A fatal error occurred: Timed out waiting for packet content
A fatal error occurred: Timed out waiting for packet content

all my thanks for your help

]]>https://community.m5stack.com/topic/2605/m5paper-error-messageRSS for NodeMon, 16 Mar 2026 21:02:00 GMTTue, 15 Dec 2020 08:58:51 GMT60<![CDATA[Reply to M5Paper error message on Wed, 30 Dec 2020 21:32:15 GMT]]>@Powersoft
Hello, after contacting M5Stack support the problem is probably the flash chip, M5Stack is replacing my M5Paper.
I had performed this upload test at slow speed but without improvement. Thanks for your help

]]>https://community.m5stack.com/post/11451https://community.m5stack.com/post/11451Wed, 30 Dec 2020 21:32:15 GMT<![CDATA[Reply to M5Paper error message on Tue, 29 Dec 2020 15:07:26 GMT]]>@zamzam
Do you have tried to slow down the upload speed. Had the same with other brands, after reducing the upload speed it works.
Succes,
Jan

]]>https://community.m5stack.com/post/11419https://community.m5stack.com/post/11419Tue, 29 Dec 2020 15:07:26 GMT<![CDATA[Reply to M5Paper error message on Thu, 17 Dec 2020 15:41:31 GMT]]>Hello, i tried the "Factory test" firmware using the M5Burner and EasyLoader_M5Paper_Factory_Test but there is the same message.

]]>https://community.m5stack.com/post/11256https://community.m5stack.com/post/11256Thu, 17 Dec 2020 15:41:31 GMT<![CDATA[Reply to M5Paper error message on Thu, 17 Dec 2020 03:11:28 GMT]]>Hello, are you having the same issue when you trying to burn the UIFlow firmware using the M5Burner? could you try and see if the M5Burner gives you any problems?

]]>https://community.m5stack.com/post/11245https://community.m5stack.com/post/11245Thu, 17 Dec 2020 03:11:28 GMT