<![CDATA[Port "E", Port "Custom" and Pogo]]>Hi all,

Port "E", where can I find it?

Port "Custom", these are pins from the bus, right?

Pogo pins, they are only for charging, right - using them as interface is not possible?

Sorry for these question, but due to my experience regarding docu - its poor - the available docu ;-)

KR,
Uli

]]>https://community.m5stack.com/topic/2878/port-e-port-custom-and-pogoRSS for NodeSun, 12 Apr 2026 20:06:53 GMTSun, 31 Jan 2021 13:45:45 GMT60<![CDATA[Reply to Port "E", Port "Custom" and Pogo on Tue, 02 Feb 2021 14:31:38 GMT]]>@uli said in Port "E", Port "Custom" and Pogo:

Pogo pins, they are only for charging, right - using them as interface is not possible?

According to the product page, the pogo pins can also be used for I2C (GPIO 21 and 22) on supported devices (BALA)
https://docs.m5stack.com/#/en/base/m5go_bottom?id=pinmap

]]>https://community.m5stack.com/post/12242https://community.m5stack.com/post/12242Tue, 02 Feb 2021 14:31:38 GMT<![CDATA[Reply to Port "E", Port "Custom" and Pogo on Mon, 01 Feb 2021 21:29:10 GMT]]>Port "Custom" is used for defining pins that are not set as the default port A B and C.
For example, if you wanted to connect an 2nd unit to a stickC you would chose the custom and then set the tx and rx pins to two of the pins from the hat connector.
As to port E well, I'm yet to find out.

]]>https://community.m5stack.com/post/12236https://community.m5stack.com/post/12236Mon, 01 Feb 2021 21:29:10 GMT