Out of the box the sample ran fine. Downloaded M5Burner, and flashed 1.6.3 firmware, but it does absolutely nothing after it completes (no lights, no reset, no power on). The only firmware I have been able to get working are the Beta-Core2 firmware, and they only seem to work with flowui.
I downloaded and installed everything in arduino IDE, and can upload my code successfully to the board, but again, once completed nothing happens (screen black, no green light on bottom) regardless of button presses. Am I doing something wrong?
Best posts made by Sparkinman
-
New Core2 appears to not be working properly?
Latest posts made by Sparkinman
-
RE: Core2
I got mine, and can’t get Arduino to work. I followed the above settings, it finishes uploading, then it says resetting via rest pin, it never resets, and never powers on again until I flash the alpha firmware. Anyone have thoughts, I’ve tried different baud rates, still no success.
-
New Core2 appears to not be working properly?
Out of the box the sample ran fine. Downloaded M5Burner, and flashed 1.6.3 firmware, but it does absolutely nothing after it completes (no lights, no reset, no power on). The only firmware I have been able to get working are the Beta-Core2 firmware, and they only seem to work with flowui.
I downloaded and installed everything in arduino IDE, and can upload my code successfully to the board, but again, once completed nothing happens (screen black, no green light on bottom) regardless of button presses. Am I doing something wrong?