Support for node
just received a node bases and i was wondering if there is some plan tu support that bases on UIFlow.
I tried without any luck to use:
- RGB : supported only 10 of 12 leds
- DHT12: env unit can't work because require also BMP280 or fail )
- IR: Can't use as unit because mapped on different pins
Of course i don't expect to use WM8978 via UIFlow, but at least the most common components mentioned above
the RGB control : you can add a RGB LED Unit function.
then change the pin seting and RGB total number like below:
neopixel0 = unit.get (unit.NEOPIXEL, (Signal_pin,), LED_total_numbe)
the DHT12: you can use the I2C function, to read the seosor data, in the UIflow navigation demo option already provide example.
the IR control : you can add a IR Unit function. then change the pin seting like below:
ir1 = unit.get(unit.IR, (Trasmiter_pin, receive_pin))
thanks, is clear.
Only one question|:
Which demo you refer to?
@ecasti the DHT12 demo:
I'm using Desktop version and not all demos are there,
anyway i found that on the online version,
thanks a lot
@ecasti ok. the desktop IDE will update the demo program in next version