@felmue
Thanks for your reply's
I am thinking
- Buy a m5stamp s3 and try that
- Wait for new batch of dials buy one see if thats different
- Figure out how to use the idf (not likely)
Thanks for getting back to me so quickly
@felmue
Thanks for your reply's
I am thinking
@felmue
I tried your program thanks
i changed pin 1 23-400 and 400 - 23
and both pins follow pin 1
I erased and burned 2.0.4 hotfix twice
I checked it with thonny and it says its still at 2.0.3
MPY: soft reboot
_ __ _
_ ()/ | | _____ __
| | | | | || |/ _ \ \ /\ / /
| || | | | | () \ V V /
_,||| ||___/ _/_/ 2.0.3
[INFO] Syncing resources...
[WARN] WiFi not connected.
[WARN] quit sync.
MicroPython v1.22.0-dirty on 2024-04-16; M5STACK Dial with ESP32-S3-FN8
Type "help()" for more information.
@felmue
Thanks
I find that pin 2 follows pin 1 with scope
try setting the duty cycle of pin 1 and watch pin 2
setting duty cycle of pin 2 does nothing
simpler test
put led load with 330 ohm resistor on each pin and timer for each at different times
pin 2 led never lights but on scope it toggles 0- -3.3 volts
I have 2 units and both do this is something wrong in the pin map set with idf?
I am trying to use Port B (Black Port) G1 and G2 as PWM and direction outputs
Both UIflow 2.0.3 and arduino don't seem to make Pin 2 as output but no warnings
I have read the documentation of S3 and I see no reason that both pins cannot be outputs
I know on Tough one of the pins could only be input but i see no reason for this on s3
What am i missing