UWB module not communicating through UART
-
Hello,
I purchased the UWB module (DW1000) and I currently have the device connected to a USB to UART bridge (CP2102). I cant seem to be able to send AT commands through the UART.
I made sure device is communicating by disconnecting the device and connecting it back to the UART bride. I use putty (buad rate 115200 per documentation) and see that there is chatter. I have also tried to switch the RX and TX lines. I have also verified that my USB UART bride is outputting 5V.
The documentation says if you input the command "AT" it should return a message "OK", but I do not see that. If you have any advice on why this module is not working I would appreciate it!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login