Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Senseair S8 LP CO2-Calibrate

UIFlow

1 Posts 1 Posters 2.8k Views

W Offline

Wolli01
last edited by

can I set the G26 pin on the M5StickCPlus to GND for about 5 seconds in software?
If so how would that be possible.

Enclosed an example for an ESP 8266

On CalibrateS8 do
GPIO,14,0
TimerSet,1,5
EndOn

On rules#timer=1 do
GPIO,14,2
endon

On System#Boot do
GPIO,14,2 // Sets GPIO14 (calibration PIN) to high impedance
EndOn
1 Reply Last reply
Reply Quote 0

Hello! It looks like you're interested in this conversation, but you don't have an account yet.

Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.

With your input, this post could be even better 💗

1 / 1