M5STack Tough in reboot loop when using UIFlow - Duplicated post
-
I am duplicating the same post I put in the Products forum because this may be the better place to discuss.
Hello Forum, M5Stack team,
I have two M5Stack Tough units. After flashing with the UI Flow Software 1.9.8 (also tried 1.9.6) the units work fine first, but then after some programming in micropython they stop working and if I reset or power on they enter a reboot loop where the unit boots until the UI Flow logo, sometimes until the audible ping, but then resets again.
Flashing with different software works. So the units do not seem to be damaged physically.
Supplying with 12V through the RS485 connector does not change the behavior.Any ideas?
-
-
Thank's that solved it!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login