DIY Mini Proto Board
-
@SR Here are a protoboard case STL file. If you are capable you can redesign and make for your own.
-
@Kryten Thank you, this looks already good.
Better would be the housing of the base board because I need to align the pin break out area with the stands of the proto board. But it's a beginning.
-
@SR aWho big is your Proto board? any drawing?
-
It's a standard 7x5 cm board with interconnected holes. The mini bread board on it measures ~ 4.5 x3.5 cm.
-
Cool. I will see if can find the time to make a "shield" like that. So you just move the bottom PCB and battery (if needed) over to the printed version.
-
My idea for a housing of the proto board would be more like a case that can pick up the complete M5Stack inclusive the button board without disassembling it at all.
-
Like this?
-
No. There is the button module completely replaced. I would like to keep it attached. I thinking about some kind of encloser around the housing of the M5Stack with a slide in mechanism. That was also the reason way I was asking in this thread for STL model of the hole case.
-
So you want to hae the M5 as is and slide in to a module with your protoborad on?
Something like this?
-
Yes, pretty close to your design.