Sharing Code for RC Servo tester
-
Hi.
I just start code m5stack for 2 day (My model is m5stack fire).
This code support 3 mode .-
Manual Mode. You can set RC servo from 0 to 180 degree.(10 degree per step.)
-
Center Mode. This mode will lock servo at 90 degree.
-
Sweep Mode. This mode will loop sweeping servo to 0, 90 and 180 degree then sweep back to 90 and 0 degree.
-
-
Well, that’s a bit more interesting then my attempt at a servo tester. Thank you for sharing. Do you mind if I add it to the UIFLOW handbook?
-
Very cool, could i add it in uiflow example
-
@pattiuak said in Sharing Code for RC Servo tester:
Hi.
I just start code m5stack for 2 day (My model is m5stack fire).
This code support 3 mode .-
Manual Mode. You can set RC servo from 0 to 180 degree.(10 degree per step.)
-
Center Mode. This mode will lock servo at 90 degree.
-
Sweep Mode. This mode will loop sweeping servo to 0, 90 and 180 degree then sweep back to 90 and 0 degree.
Ahh, wrong port was set, now working on the Black Core.
-
-
@ajb2k3 I don't mind. Please do it.
-
@heybin Please do it.
-
@pattiuak said in Sharing Code for RC Servo tester:
@ajb2k3 I don't mind. Please do it.
Thank you Very Much!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login