PaperS3 cannot compile demo
-
Hello,
I just got My M5PaperS3 and I try to compiler the demo as shown in the tutorial Adruino M5PaperS3 but if get the following error:c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c: In function 'init_bus_gpio':
c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c:339:28: error: 'lcd_periph_signals' undeclared (first use in this function); did you mean 'rmt_periph_signals'?
339 | DATA_LINES[i], lcd_periph_signals.panels[0].data_sigs[i], false, false
| ^~~~~~~~~~~~~~~~~~
| rmt_periph_signals
c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c:339:28: note: each undeclared identifier is reported only once for each function it appears in
c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c: In function 'init_lcd_peripheral':
c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c:487:26: error: 'lcd_periph_signals' undeclared (first use in this function); did you mean 'rmt_periph_signals'?
487 | periph_module_enable(lcd_periph_signals.panels[0].module);
| ^~~~~~~~~~~~~~~~~~
| rmt_periph_signals
c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c: In function 'deinit_lcd_peripheral':
c:\Users{user}\Documents\Arduino\libraries\epdiy\src\output_lcd\lcd_driver.c:562:25: error: 'lcd_periph_signals' undeclared (first use in this function); did you mean 'rmt_periph_signals'?
562 | periph_module_reset(lcd_periph_signals.panels[0].module);
| ^~~~~~~~~~~~~~~~~~
| rmt_periph_signalsexit status 1
Compilation error: exit status 1
Where the lcd_periph_signals should be defined ?
-
I found the mistake: replace "lcd_periph_signals" by "lcd_periph_rgb_signals.
-
@JNVoirol
Just switch the esp32 library version in the boards manager to below 3.1.0.
