M5Atom based power turns on briefly before user code runs
-
I have two
M5Atom
based controllers including:They both run nicely being controlled over MQTT or BLE.
But any devices connected that need power are receiving a quick amount
of power when theM5Atom
is turned on. This occurs before my software runs - so before I can decide whether the power should be on or off.So for the
H-Driver
, the connected small motor gets a quick jolt of power before my software runs. For theAtom Socket
, the same quick power on occurs (turning on the connected device) before my software can determine the correct on/off mode.Is there any way to stop this? It's not good (actually it's rather bad).
Thanks,
-
K konacurrents referenced this topic