Force reset M5 stack
-
After inadvertently uploading a sketch that outputs to wrong pin numbers one of our M5 stacks has become un-uploadable. That is whenever it's given power the speaker emits loud continuous buzzing and the hardware won't show up as a serial port.
Is there anyway to force hardware into an uploadable state and reset.
Hardware is original M5 stack without 4mb psram -
@keptan
We managed to fix it
simply holding down button A and reset button until Arduino ide attempted to connect
then releasing it and allowing it to upload without a chance for the old code to run -
For the m5stack fire you need to follow these steps
- Remove all modules, leaving only the host
- Then try to lower the baud rate when burning
- If there are wires, you can short-circuit G0-GND before powering on the device and then power on again.
