How to use CAN UNIT
ryokurta256 last edited by
I got a CAN UNIT that connects with the GROVE interface.
When I tried the code linked below in the test, it worked on M5Stack Fire, but not on M5Stack Basic.
I assigned the TX and RX settings to GROVE PORTA.
It worked with this content on Fire.
I also confirmed it with M5Stic-C, but it still did not work.
Are there any settings that I have forgotten?
gschora last edited by
@ryokurta256 Did you solve this? I'm having the same trouble with the M5Tough. It works on the Fire but not on the Tough...
did you have to add a terminal resistor between the H and L lines?