Bootloop
-
Did anybody seen similar?
I have no idea how to repair.

-
Hello @Kabron
If you cannot download firmware automatically anymore you'll need to force your M5Stack device into download mode manually. Connect a wire between GPIO0 and GND. Then power on the device. It should now be in download mode:
rst:0x1 (POWERON_RESET),boot:0x0 (DOWNLOAD_BOOT(UART0/UART1/SDIO_FEI_FEO_V2)) waiting for downloadWhen you see that output you can remove the wire and proceed to download new firmware.
Note: if you do not remove the wire you can still download firmware, but upon resetting the device it will go into manual download mode again instead of running the new firmware.
Thanks
Felix -
Right, OK, nobody panic!
There is a bug somewhere that causes a random boot loop to appear in the ESP32 and strangely I had this with a Stamp the other weekend.
Disconnect everything and leave the controllers unconnected for a while, cold boot the computer and try and flash UIFLow firmware.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login