WiFi Config help
-
I haven't managed to get the Wifi working with my M5Stack Core2.
My modem recognizes the M5 device but I am greeted with a red colored WiFi signal on the device. There is not internet connection happening.
Can someone please assist with this screen...
WiFi Cofig
SSID: M5-520
IP: 192.168.4.1Connect this SSID and open the IP in your Browser, enter the WiFi password.
My Modem does not recognize 192.168.4.1 It does nothing. My network uses a different IP address. Also, my network has an SSID (network name) so where do I enter this new SSID?
Please assist.
-
Hello @Flow
this screen means that your M5Core2 has started a temporary access point (SSID: M5-520/no password/IP: 192.168.4.1) and is waiting for you to connect to it with a mobile phone, tablet or computer to finish the configuration.
When you do that and then use a browser entering 192.168.4.1 you'll be presented with the M5Core2 configuration screen where you can enter the final SSID/password of your own modem/router and confirm. M5Core2 should then reboot and connect to your modem/router.
Thanks
Felix -
Thanks Flow....but no go!
I can confirm the M5stack is connected via WiFi to the modem - that part works OK.
It just does see the Internet.Two questions:
In Setup mode "Select WiFi" there is a number appearing which seems to be associated with a WiFi phone I have connected to the same modem. Starts with 09......
Any ideas on why that appears on the M5stack and how I can edit it if required?
Even when I hard wire into the modem and enter 192.168.4.1 on my Browser, this eventually times out as it doesn't find anything associated with that IP.
Thanks
-
Are you sure that your computer has connected to the the M5-520 access point using your computers wifi manager?
IF you not able to access 192.168.4.1 it means
- you are not connected to the M5Stack device,
- you may need to refresh the firmware using the M5Burner program.