🤖Have you ever tried Chat.M5Stack.com before asking??😎
    M5Stack Community
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Groups
    • Search
    • Register
    • Login

    Atom Switch TX/RX Pins

    Modules
    2
    3
    2.7k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Uzr66U
      Uzr66
      last edited by

      Hello... I have an ATOM-HUB SWITCH and I see on the label there are Rx(33) and Tx(23) pins available. I assume these are hardware serial pins that are available for use but I can't figure out how to connect wires to these pins. There are two holes at the end of the Switch where the label indicates the pins to be but I can't see how I would connect to them. Do I need to open up the Switch case to access them?

      Thanks,

      Greg

      ./greg

      1 Reply Last reply Reply Quote 0
      • felmueF
        felmue
        last edited by

        Hello @Uzr66

        from what I can tell from the ATOM HUB SwitchD schematic those two GPIOs (33 and 23) are used for the RS485.

        Thanks
        Felix

        GPIO translation table M5Stack / M5Core2
        Information about various M5Stack products.
        Code examples

        1 Reply Last reply Reply Quote 0
        • Uzr66U
          Uzr66
          last edited by

          Thanks @felmue , I did notice that too so I used continuity tester to see if andy of the RS-485 terminal screws were directly connected to the header pins that connect to the Atom's 33/23 pins I did't detect any continuity. I want to connect a Nextion Display that uses a Serial connection to the Atom Switch and was hoping to utilize Pins 33/23. I'm thinking I may need to purchase something like the MAX485 RS-485 module to attach to the Nextion display and run my serial connection over this RS-485 connection. Think I have some reading to do. ;)

          ./greg

          1 Reply Last reply Reply Quote 0
          • First post
            Last post