Hi Teastain, thanks for your response. We will try and create a model in Fusion 360 using the physical dimensions. Thanks for your help.

Hello, we are using the M5 Dial in a project to build a touch screen controller for an aircraft and need it to complete the modeling in Fusion 360 of the electronic and hardware design

@PharkieB Here is one that I made a while back M5Dial.stl

OK, I figured this out. Turns out my Arduino [Partition Scheme] setting was incorrect. I had a setting of
[Default 4MB with spiffs (1.2MB APP/1.5mn SPIFFS]
instead of....
[8M with spiffs (3MB APP/1.5MB SPIFFs]

Now after the sketch upload, I get
Sketch uses 1265261 bytes (37%) of program storage space. Maximum is 3342336 bytes.

Programming the M5Dial with an Arduino sketch and getting the following message after successful programming:

"Sketch uses 1265041 bytes (96%) of program storage space. Maximum is 1310720 bytes."

This means that I only have 1.3MB of program space.....But the M5Dial has 8MB of Flash.

Is there any way to access the additional space for my sketch?

Hi Teastain, thanks for your response. We will try and create a model in Fusion 360 using the physical dimensions. Thanks for your help.

Hello, we are using the M5 Dial in a project to build a touch screen controller for an aircraft and need it to complete the modeling in Fusion 360 of the electronic and hardware design

Does anyone have a 3D file of the M5 Dial?

Thanks

@felmue, thanks very much, This worked perfectly.

@ajb2k3 said in M5Dial TFT_eSPI pinout:

M5

Thank you.

Can any one get this simple GC9A01 test to run on the M5Dial

• https://github.com/carlfriess/GC9A01_demo

My goal is to have LVGL running on the M5Dial so I am working my way through the display issues at this time.