Posts made by Alf

At the moment, nothing is working at all and I think the software maintenance is extremely neglected.

The Arduino cannot be installed because there are errors in the installation routine:
No valid dependencies solution found: dependency 'Micro-RTSP' is not available

the Timer Cam api does not return any images:
{"err_msg": "QPS need < 0.2", "err_no":3304, "sn":""}
and yes the token was regenerated several times.

IN UIFlow, the cam cannot be used on its own, only as a unit.

Please make improvements here,

I have tried all firmware in the burner and none of them work, which is very frustrating.

Alf

No Support for SKU:M121 4-Relais Module
Please add it.

My sensor only shows me the RAW data.
The values of R G B (single) are always 0.

UI V1.3.2 / V 1.4.0

Contains a calibration table which is probably wrong:

1. values smaller than 0 must be set to zero
   If the calibration table matches the integration time of 154 MS. The Arduino example assumes 50 MS.

3 The module reacts logarithmically. So it should not be approximated with a 3rd degree function !

Could this be checked?
I would like to make an instruction video on my Youtube channel (UI Flow),
but I can't get any further.

Alf

I'm a beginner, and I don't know if I did anything wrong.
Please have a look at my picture.

thanks alf

When I read the sensor data , I always get 255 on RGB only with the RAW data I see that something changes when the color changes.

Is there a table or do you have to do something before reading the data?

If anyone can help me, I'd be very grateful.

greet Alf