Ah, thank you.
I am right in presuming you use the "getBatteryLevel" block, link to a variable and then print the variable, there is no other process to do?
Have to wait if gets fixed then, I suppose.
Ah, thank you.
I am right in presuming you use the "getBatteryLevel" block, link to a variable and then print the variable, there is no other process to do?
Have to wait if gets fixed then, I suppose.
Thank you Thrasher all working now.
Burned firmware 1.3.2.
Cheers.
Hi,
I am new to M5Stack, have the M5Stack Fire with ENV III.
Loaded and run the ENV example but get message "ENV unit maybe not connect".
Please advise hwo to check what is wrong and hwo to correct.
Regards
Ah, thank you.
I am right in presuming you use the "getBatteryLevel" block, link to a variable and then print the variable, there is no other process to do?
Have to wait if gets fixed then, I suppose.
I see the "Power" option in UIFlow but struggling to work out how to use, please any pointers?
I get messages like "no attribute 'getBatteryLevel' not sure what it is referring to.
I have tried assigning to a variable, so just not getting it.
Thank you Thrasher all working now.
Burned firmware 1.3.2.
Cheers.
Thank you.
Yes, but it fails saying no device attached.
Hi,
I have just got my M5Stack Grey but when I connect to the PC it runs the demo sketch.
When I run UIFlow Desktop it sees COM11 but when I press "OK" it says "connecting M5 ..." then an error message pops-up saying "Unable to upload ...".
The message at bottom left of UI says "COM11" [disconnected].
Plesse help what have I missed, it is easier on the M5Stack Fire it has the option for USB mode, but the Grey appears not the same.
I have pressed all the buttons while plugging in the USB cable but no joy.
Regards