Posts made by huberth16

Thank you for your reply "ajb2k3". I re-burned the firmware and also got a new API code and still get the same messages. Is any other idea?

In advance thank you all the community for the suport.

Hello all,

I'm new to using M5stack core (the first and basic one). I installed the driver and followed the tutorials, everything was ok until I tried to connect and run a program from the M5Flow to the core in online mode. When I trying to connect or run a program the interface said the following message:

"No permission. The device has been bound!"

in the corner, where is the API KEY, it said the word "disconnected", if I press "refresh", it turned for a while in "connecting" and then go back to "disconnected"

The interesting part for me is that if I do it offline, everything works fine but when I want to work online I got this message.

I searched at the forum and in google and found no answer. Can anyone help me?

In advance thank you so much.