Hi,
I only have one switch available at the moment, but I will see if I can test with another one.
Using the FTDI to set the IP without a full reprogramming would be ideal, but I might as well just reprogram it with a static ip.

Thank you for the help!

Thank you for the help Felix!
Just connecting the GND, TX and RX worked perfectly.

The camera is however not allocated an IP address as it says it is 0.0.0.0.
I have it connected to an ethernet switch with DHCP enabled. Reading online I see several people having problems using the W5100 ethernet controller with switches. Is this something you are aware of?

Is it possible to use the FTDI adapter to program a static IP to the camera without modifying the adapter or do I need to buy the official downloader board?

I recently received the PoECAM and want to connect to it with a FTDI cable (using the FT232RL IC).
The printed labels are not very helpful, can someone confirm the pinout of the camera? Studying the schematic I have:
3v3 - 3v3
G1 - TX (of PoECAM)
G2 - RX (of PoECAM)
G - GND
G0 - RTS
EN - CTS

Given this is correct, I should be able to use the FTDI adapter to get the IP address when the PoECAM is connected to a eth. switch, right?