Meanwhile I can confirm that the method described by @kuriko worked for me 100%!
I had two "bricked" QR-Code2 scanners and both are alive again!
S
Best posts made by Scotty42
-
RE: I can't use ATOMIC Barcode/QR-Code Scanner 2 Base after factory reset
-
RE: I can't use ATOMIC Barcode/QR-Code Scanner 2 Base after factory reset
@kuriko Thanks! Principle is understood: <AW> is the barcode prefix equivalent for "configure write" which when sent over serial would be "21". "424000" is the code for setting the comms interface to RS232. So it seems as if the factory reset code sets the comms interface to something else than RS232.
Do you by any chance also have the barcode prefix equivalents for "Configure read 0x23", "Control instruction 0x32", "Status reads 0x43" or point to any document where this is explained ?
I currently don't have access to the "bricked" QR-Code Scanner but I will test and report back as soon as possible!