Posts made by Testing123

Thanks ondrej1024 for scripts!
This is very good for temporary fix.
For permanent fix, I hope one day M5Stack add the option to dis/enable audio in firmware.

Since Core 1 UiFlow firmware doesn't beep during boot, I am using this Core 1 with UiFlow for experimentation while using Core 2
with Arduino. Once gain enough knowledge with Arduino programming, perhaps getting rid of UiFlow altogether...

Hi @felmue, thanks for your confirmation.
I am going to add this request to the Wish List.

Hi @agreedk, thanks for your reply.

It has nothing to do with the programming.

To replicate what I am talking about:

1. Using latest M5burner, select UIFlow(CORE2) and burn firmware "v.1.8.8-core2"
2. Power cycle the device. Every time the dot above the "i" appear, it emitting a tone. Please see the picture below.

3. After reboot, the screen is shown as below.
   

Therefore it has nothing to do with our programming as I haven't even load any test program yet.

Hi All,

I found it is extremely annoying that the tone is emitting every time the core2 is powering up. It is annoying because it wakes my kid up and annoying people around me. The tone does not emitting on original core1.

It is okay to have such a "wonderful / magic" tone but MUST HAVE OPTION to turn it off in the setting.

I have searched on this forum but could not found what I am looking for... If any know, please give advice. Thanks!