I am not able to find the method to drive the gripper servo within the hat using UIFlow. There are only 3 methods available in UIFlow:

• Set the wheel pulse
• Set wheels pulse for all wheels
• Set RoverC speed

Thanks.

There is a block at top:

Init timezone [ x ] formatting [ y ]

I know the [ x ] is a number matching my timezone for the GPS, however what should be put in the [ y ]?

The documentation is lacking.

This code worked for me:
from m5stack import *
from m5ui import *
from uiflow import *
import i2c_bus
import hat

setScreenColor(0x030545)

hat_roverc1 = hat.get(hat.ROVERC)
label0 = M5TextBox(57, 6, "RoverC", lcd.FONT_DejaVu40, 0x01e2b1, rotate=90)

i2c0 = i2c_bus.easyI2C(i2c_bus.PORTA, 0x38, freq=400000)
i2c0.write_mem_data(16, 80, i2c_bus.UINT8LE)

I am not able to find the method to drive the gripper servo within the hat using UIFlow. There are only 3 methods available in UIFlow:

• Set the wheel pulse
• Set wheels pulse for all wheels
• Set RoverC speed

Thanks.