@Powersoft
Hello, after contacting M5Stack support the problem is probably the flash chip, M5Stack is replacing my M5Paper.
I had performed this upload test at slow speed but without improvement. Thanks for your help
Z
Posts made by ZamZam
-
RE: M5Paper error messageposted in Cores
-
RE: M5Paper error messageposted in Cores
Hello, i tried the "Factory test" firmware using the M5Burner and EasyLoader_M5Paper_Factory_Test but there is the same message.
-
M5Paper error messageposted in Cores
Hello,
When I upload an arduino program to M5Paper then there is the following message in the Arduino IDE:
esptool.py v3.0-dev
Serial port COM6
Connecting....
Chip is ESP32-D0WDQ6-V3 (revision 3)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: b8:f0:09:c6:29:10
Uploading stub...
Running stub...
Stub running...
Configuring flash size...
Warning: Could not auto-detect Flash size (FlashID=0xffffff, SizeID=0xff), defaulting to 4MB
Compressed 8192 bytes to 47...
A fatal error occurred: Timed out waiting for packet content
A fatal error occurred: Timed out waiting for packet contentall my thanks for your help