This project is developed by users. As you said, the whole project has not been automated yet. It is currently only in the development stage, and the automation function may be completed in the future, and we will continue to follow up.

You can use the robotics arm with AI Kit, only download the project.

i have just that MCP9600great

0_1676119689985_abe5939f-a3ca-482e-a0a0-0bc08ef52c64-image.png

is this suppose work that example setup? it show only 55,9 C and i2c address is right

Hi @kombistack,

it seems they have updated the filter functions (see https://github.com/sensorium/Mozzi/pull/165) and although they say that it should be backwards compatible, it obviously is not.

I developed for Mozzi 1.1. I have put that version on my site (https://www.oscillator.se/opensource/#m5stack). Can you try it and report back?

Thanks for using OscPocketM!

Wow, it's been 2 years but i finally found time to work on it. Here it is:

M5Seismo

Here is the code on github.

Thank you. If you had the choice, which robotic arm would you choose?

@ajb2k3 Yes I removed the loop because I wanted to add the restart option at the end of the code to use the low power mode basically.
So now, it restarts, reads and sends the data, and goes to sleep.

Not quite correct, it is the computer that is needed to transfer the data and send the commands to mycobot.

I'm very sorry about that. This forum does not allow GIFs.
Watch it on hackster if you're interested in watching it!

@pengyuyan
The m5stack-basic esp32 is mainly used for the Internet of Things. The robotic arm needs a bridge to connect to the computer, where the m5stack-basic esp32 development board is used, which also powers the arm. We have set up some microPython in the m5 to facilitate using some functions.

Thank you for your support. Yes, we are developing VR communication and the idea is to be able to control mybuddy from a remote location via VR to implement some projects.