M5Paper error message
-
Hello,
When I upload an arduino program to M5Paper then there is the following message in the Arduino IDE:
esptool.py v3.0-dev
Serial port COM6
Connecting....
Chip is ESP32-D0WDQ6-V3 (revision 3)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: b8:f0:09:c6:29:10
Uploading stub...
Running stub...
Stub running...
Configuring flash size...
Warning: Could not auto-detect Flash size (FlashID=0xffffff, SizeID=0xff), defaulting to 4MB
Compressed 8192 bytes to 47...
A fatal error occurred: Timed out waiting for packet content
A fatal error occurred: Timed out waiting for packet contentall my thanks for your help
-
Hello, are you having the same issue when you trying to burn the UIFlow firmware using the M5Burner? could you try and see if the M5Burner gives you any problems?
-
Hello, i tried the "Factory test" firmware using the M5Burner and EasyLoader_M5Paper_Factory_Test but there is the same message.
-
@zamzam
Do you have tried to slow down the upload speed. Had the same with other brands, after reducing the upload speed it works.
Succes,
Jan -
@Powersoft
Hello, after contacting M5Stack support the problem is probably the flash chip, M5Stack is replacing my M5Paper.
I had performed this upload test at slow speed but without improvement. Thanks for your help
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login