Constantly increasing magnetometer reading
-
Hello --
This is my first post, having recently received an M5Stack Fire. I've successfully programmed it from the Arduino IDE, and am receiving good data from the accel and gyro. However, the magnetometer reading constantly escalates (and eventually rolls over), even when the unit is sitting flat, unmoving on the table. It steadily escalates about 3 degrees per second. Is this an issue of calibration? (It seems that if it were a calibration issue it would be off by some consistent amount.) Any suggestions? -
@butch Did you ever figure this out? I am having the same issue.
ChristopherO
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login