Modbus Master crashes and missing documentation

[insaneLX]

Hi,
I am trying to create a modbus master application in micropython. I cannot figure out how to use the write_single_coil register as I get a ValueError: Illegal coil value when using following line:
modbus.write_single_coil(1,0, 1, timeout=500)

Also, the documentation on Modbus is really flaky - can you point to some examples or maybe the source code of the implementation so I can look it up?

[felmue]

Hello @insaneLX

from earlier posts I assume you're trying with an M5Tough, correct?

Well, I can confirm that write_single_coil fails with Value Error as soon as the value is different from 0.

So, yes, I'd say it is broken. @m5stack could you please look into that. Thanks.

BTW: other Modbus blocks like write_single_register work for me.

Thanks
Felix

[insaneLX]

Felix, thanks for the reply.
I was trying to use the write_single_coil as workaround. I wanted to use the write multiple coils function. But it does not have a parameter to set the number of coils to be written and the documentation is less than complete. Any ideas? How does the system know what to write?

[felmue]

Hello @insaneLX

I think the multiple coils function takes a list, but it didn't work for me either.

Thanks
Felix

[insaneLX]

A list it is!

try:
ret = modbus.write_multiple_coils(comms.DEVICE_ADDRESS, 0,(
sig.smoke_flap,
sig.transport,
sig.ignition,
sig.smoke_fan,
sig.extinguish,
sig.flood,
sig.ember_air,
sig.alarm
), timeout=200)

works nicely.

[pandian.nano]

Hi, @insaneLX
0xff00(ON or 1) and 0x00(OFF or 0)