"Download", and now I cannot connect to M5StickC
-
If I write any code in M5Flow 1.41-beta OR 1.32 and then "download" the code and run it on my M5StickC, there doesn't seem to be any way to get back to using M5Flow. The device appears to be completely disconnected from the network, not responding to further "download" commands, and can't even run code.
Solved
When the device reboots, instead of allowing it to reboot and run the downloaded code, hold down the reset button AND the button B at the same time, then the device will go back into a monitoring mode.
Is this documented anywhere? -
Nice, good to know,
havent seen it documented anywhere tho.
I always used to "run" code instead of download it with stickC, but once I downloaded it, I simply re-firmwared device. -
@thrasher err I still have to log this in my books but it was on one of the official stick documents.
-
@ajb2k3 really? I probably missed it, was too hasty to try out hardware :]
-
@thrasher Yes that's what I was doing, and thought there must be a better way.
There are a couple of operations that require the 'download' method of installation, and will not work in the 'play' mode. -
@thrasher I wouldn’t worry to much as I keep forgetting the sequence
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login