UiFlow Beta 1.4.1

m5stack

Ver 1.4.1. time : 2019.10.12

1: Add some HAT support（Servo、Servos、PuppyC、Joystick、BugC、Finger、BeetleC、YUN）.
2: Add GPS Unit support
3: Fixed some bugs.

updates_pic1
updates_pic2

ajb2k3

Looks like I have some updates to make

ajb2k3

Ver 1.4.1. time : 2019.10.12

1: Add some HAT support（Servo、Servos、PuppyC、Joystick、BugC、Finger、BeetleC、YUN）.

2: Add GPS Unit support

3: Fixed some bugs.

1.4.1 not is osburner software yet

Thrasher

Yet no rs485 unit for stick-c in the list (:

Mati

nice, still waiting for PM2.5 SHT20 readings with is missing.

ajb2k3

@Thrasher theres still a lot of RS485 work to be done and I'm tormenting the programmer over it.

@Mati Same here.

ajb2k3

@thrasher said in UiFlow Beta 1.4.1:

Yet no rs485 unit for stick-c in the list (:

OK To use the RS485 Hat you need to use the UART setup block and set TX =0 and RX = 26.

Sorry, taken me all day to workout the code blocks and convert a sample code briefly seen in a demo video.

Thrasher

Thanks, I will give it a try tomorrow!

ajb2k3

@thrasher said in UiFlow Beta 1.4.1:

Thanks, I will give it a try tomorrow!

Just found something else
https://docs.m5stack.com/#/en/uiflow/RS485

Thrasher

ajb2k3,
Sorry I didnt have chance to test today, Ive lost my max485 ic somewhere lol, cant connect m5stick anywhere else.
I looked through link but it needs testing, as far as I remember rs485 differs from rs232 as its a half duplex and I used to enter send/listen modes by pulling some pin up or down. Hopefully m5stacks unit does that for me with the code from the link because I cant see any interraction with control pins in the code

Thanks

ajb2k3

@thrasher That page was hard to find and I discovered it late last night. I need to set up a test rig out in the workshop but until I can do that I am unable to test the RS485.

If I get anywhere I will post in the projects forum.