M5 Core2 factory loaded "unboxing' sketch - where to find?

[Marelli7]

I was impressed by the program that runs when the core2 is unboxed. I'm curious how some of these features are programmed. And for demonstration purposes I would like to re-load this program onto the Core2.

Unfortumately I cannot find* the .ino sketch (I'm using Arduino IDE).

Does it exists, what is the sketch called* and where can I find it ??

[felmue]

Hello @Marelli7

check out this thread.

Thanks
Felix

[ajb2k3]

@marelli7 said in M5 Core2 factory loaded "unboxing' sketch - where to find?:

I was impressed by the program that runs when the core2 is unboxed. I'm curious how some of these features are programmed. And for demonstration purposes I would like to re-load this program onto the Core2.

Unfortumately I cannot find* the .ino sketch (I'm using Arduino IDE).

Does it exists, what is the sketch called* and where can I find it ??

You will find it as an included firmware in M5Burner

[Marelli7]

@felmue Thnx! found what I was looking for.