M5 Stack ADS1115 address
-
Hello, can I somehow change the address of ADS1115 at my own risk (soldering)
I need 0x4a or 0x4b
0x49 is already occupied, cannot be changed! -
@nebosa You will need a PaHub2 I2C multiplexer!
-
Hello @nebosa
check the ADS1115 datasheet (linked here under Related Link). Section 9.5.1.1 I2C Address Selection describes how to change the I2C address.
Looking at the board of my AMeter I can see that it is partly prepared to select a different I2C address. One can move a 10 k resistor from one location to another to switch between 0x48 (default) and 0x49. To select 0x4A or 0x4B requires a bit more work, I am afraid.
Below picture illustrates my modification to change the AMeter I2C address to 0x4B.
Thanks
Felix
