Help with uiflow and max6675
-
Can i somehow to read temperature via uiflow?? in arduino i succeed
-
Are you using the max6675 hooked up directly to a M5stack core ? UIFlow doesn't support SPI, but you can use Micropython as described in https://community.m5stack.com/topic/1845/micropython-spi
The M5Stack Kmeter Unit uses the max6674 and an esp32 with dedicated firmware as a SPI to I2C in addition to a thermocouple reading to temperature converter. The M5Stack Kmeter Unit has a red grove connector (I2C) and is supported in UIFlow.
-
ok too hard for me.. i have k-type sensor 1-wire version too is that easier it use MAX31850K it's i2c
-
@teacdance
1-wire isn't supported in uiflow .. you will have to add an 1-wire to i2c converter: DS2482 -> https://community.m5stack.com/topic/1796/ui-flow-support-for-onewire-and-ds18x20/10
But you can use the MCP9600 with UIFlow (I2C-protocol). -
i have just that MCP9600great
is this suppose work that example setup? it show only 55,9 C and i2c address is right
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login