🤖Have you ever tried Chat.M5Stack.com before asking??😎
    M5Stack Community
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Groups
    • Search
    • Register
    • Login

    M5STack Tough in reboot loop when using UIFlow - Duplicated post

    UIFlow
    2
    3
    2.0k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • I
      insaneLX
      last edited by

      I am duplicating the same post I put in the Products forum because this may be the better place to discuss.

      Hello Forum, M5Stack team,

      I have two M5Stack Tough units. After flashing with the UI Flow Software 1.9.8 (also tried 1.9.6) the units work fine first, but then after some programming in micropython they stop working and if I reset or power on they enter a reboot loop where the unit boots until the UI Flow logo, sometimes until the audible ping, but then resets again.
      Flashing with different software works. So the units do not seem to be damaged physically.
      Supplying with 12V through the RS485 connector does not change the behavior.

      Any ideas?

      1 Reply Last reply Reply Quote 0
      • felmueF
        felmue
        last edited by

        Hello @insaneLX

        please try the latest M5Burner and then use it to install UIFlow firmware 1.11.8 onto your M5Tough.

        Thanks
        Felix

        GPIO translation table M5Stack / M5Core2
        Information about various M5Stack products.
        Code examples

        1 Reply Last reply Reply Quote 1
        • I
          insaneLX
          last edited by

          Thank's that solved it!

          1 Reply Last reply Reply Quote 1
          • First post
            Last post