4. How to revert default coreS3 setting after burning UIFLOW?

How to revert default coreS3 setting after burning UIFLOW?

  • M

    Hi,

    Now I am using coreS3 and burned following UIFLOW.

    0_1707705149742_UIFLOW.png

    But after burning above, I cannot revert default coreS3 setting.
    (I meant cannot burn follwoing coreS3 UserDemo)
    I guess coreS3 cannot achieve serial communication.
    Is there any way to revert?

    0_1707705246538_S3.png
    0_1707705251023_Burn.png
    0_1707705257623_Error.png

    Thenk you.

    0

  • (Normally) You switch it on, old the boot button, plug in a USB cable and release the boot button and after 5 seconds the green light on the bottom comes on, M5 burner will report that a device is detected and then you can ERASE and then burn.

    0
  • M

    Hi ajb2k3,

    Thank you for your kind reply.
    I can do it with following process as you said.

    • Plug in USB cable
    • Hold Boot button (RST button) on coreS3 for over 5seconds
    • LED turned to be green
    • Enable to burn coreS3 UserDemo with M5Burner !!!

    Thank you again.

    1