Having no luck waking up my M5DinMeter from hibernation using the encoder button on G42. Anyone figure this out? My DinMeter runs on battery so using the USB plug is not what I'm looking for.

Wayne in Manchester NH USA

@felmue Thanks Felix. I see now...

Regards

Wayne in NH

haven't been able to operate the GoPlus2 module with the Atom Lite. Have grove connector from Atom pins 26,32 to PORTB1 of GoPlus2. GoPlus2 is powered by 12v and two 5g servos are connected.

I2C scan does not return a device.

setup includes:

M5.begin(true, true, false);
Wire.begin(26,32)

Anyone had success with this setup?

Wayne in New Hampshire