@Bat21hello to tod@s
There are no answers to this incident?

Am I doing something wrong?

Good afternoon,
I use UIFOLW 2 version 2.3.4 and Core basic.
I have purchased several Unit Hbridge modules with version 1.1.
When I run the "Set" commands, they work correctly, or so it seems.

When I add a "Get" command, the error shown on the screen appears.

If I use UIFOLW 2 version 2.3.5, the battery data is incorrect.
I have purchased many M5stack products, and none of them work correctly; they all have errors.
I would like to know what is happening with this device because it loses I2C communication.

And it stops working.
If I run this code, which is the one I'm interested in, I get the error shown on the screen.

Error in the image

Has this happened to anyone else?
What am I doing wrong?
Or is it an I2C port error?

How can I see the I2C address of the Unit H Bridge device?

Thanks.

@Bat21
Tested in UIFlow 1 with the sample program, it doesn't work either.
Here's the error:

I can't work with these new modules.
It's very important to me that they work.

Good afternoon,
I use UIFOLW 2 version 2.3.4 and Core basic.
I have purchased several Unit Hbridge modules with version 1.1.
When I run the "Set" commands, they work correctly, or so it seems.

When I add a "Get" command, the error shown on the screen appears.

If I use UIFOLW 2 version 2.3.5, the battery data is incorrect.
I have purchased many M5stack products, and none of them work correctly; they all have errors.
I would like to know what is happening with this device because it loses I2C communication.

And it stops working.
If I run this code, which is the one I'm interested in, I get the error shown on the screen.

Error in the image

Has this happened to anyone else?
What am I doing wrong?
Or is it an I2C port error?

How can I see the I2C address of the Unit H Bridge device?

Thanks.

@Bat21 said in Module GPS:

Any thoughts on this issue?
I'm at the end of the project, and the readings are displayed in the same format.

@Bat21 said in Module GPS:

@kuriko

@kuriko

Any thoughts on this issue?
I'm at the end of the project, and the readings are displayed in the same format.

@kuriko

@kuriko Hello, Longitude decimal "dd.dddd" and longitude "ddmm.mmmmmE/W give the same result.

Good morning,
I'm working with the GPS module and I find that the Get longitude command isn't working correctly.
The same data is output in both display formats.
The Get latitude command does work correctly.

The firmware version is V2.3.3.

It works correctly in UIFlow 1 FW V1.14.8.

Thanks

@Bat21
I can't detect any with Atom Lite.