@m5stack Can you please help here?
I've flashed 1.9.4-en and 1.9.5-en versions without luck...

It's only happening if I "run" the program. In both versions if I do the "download" then screen just go blank.

Same problem here

No solution yet?

Hello,

I'm trying to connect a GoPlus2 to my M5stack grey using Flow 1.9.5 firmware.

Code is clear and I only have a single Flow block for testing: "Set Servo S1 angle 0".

As soon as I download or run it I get a red error screen stating "GoPlus2 module maybe not connected".

M5stack is running from GoPlus2 battery and no bottom.

Am I missing something?
Thanks!

@calvorotas I'm having similar issues. What is that "adjust all pins" about? Did you had any bent pins?

My 15x2 looks good, but I'm unsure what does "adjust" mean and maybe I have to do something.

Thanks!

@felmue There's no exact information on compatibility in your links.

I found problems, then contacted directly M5 and they explained that Core2 and GoPlus2 are not compatible in a direct message.

Hope this thread helps next people.

BTW, I bought a new Core Gray device (Core1, not Core 2) but still GoPlus2 is not recognized.
I'm starting to think I'll never make it work... :'(

How do I remove and revert to standard firmware?

@felmue M5stack store just confirmed the incompatibility:

In the GoPlus2 product page:

@felmue @m5stack Is this issue a compatibility problem without solution? This is big as nothing in the GoPlus2 product points it's compatible only with some of the cores...

Shall I assume I don't have any solution?

@m5stack can I change GoPlus2 address to avoid this problem?

@dario @m5stack I have the same problem here. Is it going to be fixed?

@ajb2k3 This is the one I have: https://docs.m5stack.com/en/module/goplus2