Topics created by gadjet

lcdvol to control lcd voltage, must than 3V

@gadjet Sorry, UIFlow does not support the DHT12 which's built in BTC.

make sure you refresh the page a few times or clear your browser cache/cookies. it was there when I updated my firmware this morning (about 5 hours ago). i'm using v1.1.2 now.

@lukasmaximus said in BTC 2.0 not powering the basic M5Stack: @gadjet sorry this was definitely an issue with the description. The btc ticker is not capable of charging the m5 stack. I wouldn't mind but I bought two of them !!! Oh well back to my 3D printed stand and a big battery.

@world101 It's in the "Graphic" group ![LCD.Print]()

@dvd78 I think..... If you just power it on it should autoload the program.

@gadjet OK got it to stop making a continuous beep by adding the M5.update(); in the loop. Volume still doesn't work though.

Hi, I'm not using M5ez yet but I will give it a try, I've set the background colour but I don't think it works with M5.Lcd.print commands.

@rop thanks for the pointers, I'll have a look at both.