Posts made by heybin

please add this block

sorry, stickc only in 1.3.2, https://github.com/m5stack/M5Stack_MicroPython/tree/StickC

fixed

We are very sorry, I test it, found M5GO Bottom will affect gps module, it make uart high level only 1.5v you can try use do this， connect TXD to 34 then Knife cutting TXD to 16, and change code GPSRaw.begin(9600, SERIAL_8N1, 34, 17);

Serial2.begin(115200, SERIAL_8N1, 13, 4) and you can use Serial2 in grove

Can you show purchase link, MPU6050+MAG3110 has not been sold for a long time....

http://flow.m5stack.com/beta/ uiflow 1.3.4 support

Try arduino hat env example, if it also not work, please contact the store

sorry, this is caused by the battery voltage being too low(not booting for a long time). there is no way to solve it through the program,

Try find it in https://docs.espressif.com/projects/esp-idf/en/latest/api-reference/index.html#

UIFLOW most lib post in https://github.com/m5stack/UIFlow-Code, wiki have some api

https://docs.m5stack.com/#/en/faq q9

sure, it will available in next week

lcdvol to control lcd voltage, must than 3V

if some firmware in stickc, please connect g0 to 3.3V, next insert usbC，it will work well

sorry for reply too later, i will go to test

try this http://flow.m5stack.com/beta/
uiflow 1.3.3

We are very sorry, stick-UIFlow is stop update

BAT pin used to connect lithium battery, and if use 5v connect to ESP32 GPIO, Esp32 will be damaged

sure, but lobo micropython was stop updating