I have an M5Stack core 2 that I'm trying to get to publish to a Mosquito broker installed in Home Assistant. I can subscribe fine but I just can't get it to publish. Is anyone else having issues with this? Could it be the firmware revision? I can send topics through Node Red and receive them fine but no matter what I try I can't get it to publish.

It just didn't like the Mosquitto broker in Home Assistant I installed EMQX Broker and it works like a charm.

I would love to see Modbus TCP support in UIFlow.

Are there any good tutorials out there for the atom s3 light? I haven't had any luck getting it to run anything, not even a simple LED color change. I would love to be able to just push sensor values over MQTT but I can't even do the simplest of task. I set up Core 2s with UIFlow 1.0 with no problems but version 2.0 is a different animal. If anyone knows of some example code out there it would be much appreciated. Wanting to eventually read an RFID card and push the number across MQTT.

I click the configure button in the burner but the API key is not listed. This is my first time with the atom but Used the Core 2 and it always was there. Looked at the quick setup guide and the example picture that it shows doesn't have it listed either. Am I just stupid or blind?

Re: I can't connect the M5 Stack Core2 to WiFi in my program.

It was working then one day I booted it up and it just stopped working. I saw the reply to a previous post about this and used the example with no results. I have tried to reflash but it did not help. It connects outside the program fine. it is a hidden network but like I said it was working before.

Thanks
Rob

It just didn't like the Mosquitto broker in Home Assistant I installed EMQX Broker and it works like a charm.

Just a test setup at the moment. I can subscribe and get the topic message. When I press the buttons, the test display shows the buttons were pressed but the message does not post to the broker.

I have an M5Stack core 2 that I'm trying to get to publish to a Mosquito broker installed in Home Assistant. I can subscribe fine but I just can't get it to publish. Is anyone else having issues with this? Could it be the firmware revision? I can send topics through Node Red and receive them fine but no matter what I try I can't get it to publish.