For the Micropython version
esp32c3-20220618-v1.19.1
unfortunately the w-lan does not work properly.
Wolli01
@Wolli01
Posts made by Wolli01
-
RE: M5StampC3
-
RE: M5StampC3
Thanks for the help, I got it working now.
The downloader must be set uart instead of USB and the flash files must also be the ones without USB.
Unfortunately, various things do not run, with UIFlow I get the message M5Stack Import * is not correct. -
RE: M5StampC3
I've already tried that, but I couldn't get it to work. With the Flash Download Tool I do not come further, always stands Sync and paints only points hin over 30 min. long. Maybe I'm doing it wrong. About Thony I also do not get it done, there comes afterwards always Invalead header.
-
M5StampC3
How is it possible to get UI flow on the M5StampC3. I have not managed it via the burner and not via Thony either. With Thony comes then always Invalid Header.
-
sensirion sps30 modbus
Hello friends, has anyone here the sensirion sps30 in modbus or SCI running?
-
RE: sensirion scd30 modbus
Thank you, but I am looking for something for UiFlow, so Micropython
-
sensirion scd30 modbus
Hello friends, has anyone here the sensirion scd30 in modbus or SCI running?
-
error LcdBrightness M5StickC -Plus
hello friends,
I have four M5StickC -Plus with identical UiFlow software and identical App- software. on 3 the command goes
axp.setLcdBrightness(80) works without problems.
With one unfortunately not at all. does anyone know what this could be? -
Senseair S8 LP CO2-Calibrate
can I set the G26 pin on the M5StickCPlus to GND for about 5 seconds in software?
If so how would that be possible.Enclosed an example for an ESP 8266
On CalibrateS8 do
GPIO,14,0
TimerSet,1,5
EndOnOn rules#timer=1 do
GPIO,14,2
endonOn System#Boot do
GPIO,14,2 // Sets GPIO14 (calibration PIN) to high impedance
EndOn