Hi. I´ve followed all your instructions and could even compile properly the code. The sketch is very simple cause I only want to produce the output on TV. #include <M5Stack.h> #include "m5stack_tv.h" void setup() { M5.begin(); M5.Lcd.fillScreen(TFT_BLACK); M5.Lcd.setTextColor(TFT_WHITE, TFT_BLACK); M5.Lcd.setTextSize(3); M5.Lcd.setCursor(40,100); M5.Lcd.print("Working..."); // m5stack_tv::begin(); } void loop() { m5stack_tv::setTextColor(0); m5stack_tv::clearScreen(54); m5stack_tv::setCursor(140, 60); m5stack_tv::print("Temperature, C: "); m5stack_tv::setCursor(140, 60); m5stack_tv::print("Temperature, C: "); m5stack_tv::setCursor(140, 80); m5stack_tv::print("Humidity, %: "); m5stack_tv::setCursor(140, 100); m5stack_tv::print("Pressure, mm Hg: "); } But when running, the screen of the m5stack starts flashing/blinking and there´s no signal on the TV. I´ve connected the central cable of the RCA to DAC 25 which is not stated in your article and the external RCA to ground. It seems like there´s a conflict between DAC 25 and the M5stack screen. If I comment in setup() the line that activates TVout: //m5stack_tv::begin() and everything on void() the m5 screens starts to work as intended, so the problem is within Tv library. I use M5stack basic (the black). Any help?

@calin Yes, I am beginning to see more of that logic. But I so like to make Arduino libraries... :/ I am hoping to be able to interface with the underlying esp timers and RTC and still offer that in the arduino world. Reading lots...

To whom it may be interested I modified native arduino M5STACK library to suite both M5STACK and ODROID-GO. Look in the examples folder. Also read comments in M5Stack.h Tested with VisualMicro for Visual Studuo https://yadi.sk/d/0wo7ympO3Zc6RT [image: 1533201664680-odroid.jpg] [image: 1533202363217-odroid1.jpg]

So after all that work, the provided driver does not work.

Hi @ajb2k3, Are you actually using Arduino IDE version 1.6.5 from 2015 - or is that a typo ? From your comments, I am not sure what issue you have found. Depending what sketch you are trying to load will dictate what libraries will need to be referenced at the start of the sketch, such as those you list. If you are having problems loading the examples, perhaps pick one and outline some specific details including error messages.

@dimi 在 FACES UI Lessons question 中说： The information in the previous lesson, today is not relevant. So, these lessons only misinform us. So I ask, what is the use of them? It is better to rewrite or delete them.

@ajb2k3 在 Project Element E 中说： Brushless drivers are ok for the Brushless motors but the same board needs to replace a burned out driver in an old bike. The old bike has a 200W motor run at 36v for a total of 5.55555) amps and the FQA160's are rated at 160amps. However, I must say that those ESC's do look sweet. In this case, consider something like this: [image: gs30-esc.jpg] Is way cheaper.

Can we get some clarification on this like where the logo is stored and how its created?

So, I found my mistake, I put the 3 files in the SD card while it was put in the system file. first problem solved but now he still does not want to connect to my PA, he connects and then disconnects 5 seconds later

Great Job!