@teastain thank you!

Hello @Recyclosaucisse

you already described it correctly: G26 can be IN or OUT; G36 is IN only.

Your defines need to be swapped: SENSOR_PIN 36 and RELAY_PIN 26.

Thanks
Felix

Hello @dahult

the IP5306 I2C registers are described here (under Related link - Datasheet).

Unfortunately the IP5306 turns the output off after a timeout (max: 64 s) if the load is too low; like when ESP32 is in deep sleep mode.

There was a similar discussion in this thread here.

Thanks
Felix

Hello @toonny

try using M5Burner to either erase flash first or use the Configure button to disable LTE usage.

Thanks
Felix

@nikita-ch I also tried removing the motion sensor - same problem. So the problem is in the frame or the sensor - I do not see any other possible places for the error

What exactly is the issue?
What hardware are you using?
What error messages are you getting?
What code are you using?
What have you tried to fix the issue?

Danke für Deinen Vorschlag, werde ich mal probieren.
Ich habe es gestern doch noch mit dem PIR versucht, da dieser nur beim Auschalten eine Verzögerung von 2 Sekunden hat. Wenn der PIR auf "0" ist und er eine Bewegung erkennt, so reagiert er in meinen ersten Tests unverzögert.

Bei der Programmierung meiner Zeitmessung in Kombination mit dem PIR, reagiert dieser aber leider dennoch verzögert beim starten des Timers. Hat jemand eine Idee weshalb das so ist? Anbei ein Bild Tests:

0_1663578484972_M5Stack-Zeitmessung.JPG

@robalstona
Thank you very much.
I was able to execute it :)

thanks your recommended , we was fix this issues .

@world101

Great these work for me.

@citizen428 said in How to use M5Stack M5GO:

@lukasmaximus Sorry for the late reply, was busy with work the entire week. The manuals are indeed horribly outdated, but the community here seems nice and I now have both UI Flow and Arduino working and am currently using the latter to build a fun project. :)

Ouu I'm curious, are you ready to give any clues?