UIFlow 1.8.3

[m5stack]

Ver 1.8.3 time: 2021.0827

v1.8.3

new features:

• Add UNIT FADER support
• Add Module stepmotor driver support
• ESP-NOW support encrypt(LMK)
• New Vfunciton for UNIT V2

Bug fix:

• Fix NB-IoT MQTT downlink data parse error
• Fix ATOM-DTU Modbus UART ID error

[mory]

good job! when will the desktop IDE be upgraded?

[ajb2k3]

RGB leds won't work on M5Stamp if pins set to anything other that PORTA

[dominiclee]

I am beginner of M5Stack. I bought both M5Go and Fire, together with lots of units. When I test the OLED unit, I found it always show M5 logo with "M5STACK". i can 't fill with black or white. I can't draw rect. I can't draw line. I can't draw text. The only function works is "invert" but still only M5 logo with "M5STACK" is shown all the time. I tested it with both M5Go and Fire but same problem. Any help?

[plusulli]

with uiflow the OLED-unit shows nothing else than the M5Stack logo

[m5stack]

@plusulli

add this block after any draw.

[saitotetsuya]

The range of ids of the Set id block in myCobot is wrong. It should be from 1 to 6, but from 2 to 7.