TAB5 python Crash
-
I was trying to write an output on EXTIo2 and I got a python crash and a dump.
I then tried to update the TAB5 to V2.3.6-hotfix2.
The device programmed and the default UIFlow screen is showing, but now I cannot program the device.
I reverted to 2.3.5 and I can program the TAB5 -
Hello @scroggyg
here are the result of my tests with various firmware versions:
v2.3.5 : running program -> crash
v2.3.6 : running program -> crash
v2.3.6 hotfix : running program -> ok
v2.3.6 hotfix2 : running program -> okNote:
- I had no issue burning an running any of the above firmware versions.
- I run all my tests with no battery attached.
You can find the program I used in the UIFlow Project Zone: M5Tab5_ExtIO2_Test_UIFlow2.3.6
Thanks
Felix