Connecting M5Stack to an MQ-2 smoke/gas sensor

[Suntzu]

I am trying to port my ESP8266 project to M5Stack but for the life of me I could not figure out how to connect the wires between M5Stack and the analog MQ-2 gas sensor.

This is my wiring for ESP8266 that perfectly works:

 MQ-2 Sensor    ->    ESP8266
     A0         ->      A0
     D0         ->      D0
     VCC        ->      VIN (5.5V)
     GRD        ->      GRD

This is what I have tried in M5Stack but did not work. The sensor's D0 LED and power LED do not even lit on.

 MQ-2 Sensor    ->      M5Stack
     A0         ->        Pin 36 (I also have tried 35)
     D0         ->        Pin 21 (I also have tried 16)
     VCC        ->        5V
     GRD        ->        G

How do I wire the analog MQ-2 sensor To M5Stack? Is it doable? Any guidance please?

[JJ]

@suntzu Hi Suntu,

Try sourcing the 5V from the positive terminal on the Grove connector.

[Suntzu]

@JimiT I will try that when I get back home from the office. And I will make sure to keep you updated.

Thank you so much, Jimi.

[Suntzu]

@jimit 在 Connecting M5Stack to an MQ-2 smoke/gas sensor 中说：

@suntzu Hi Suntu,

Try sourcing the 5V from the positive terminal on the Grove connector.

It worked like a charm! Thank you again. It's time to rewrite my sketches for M5Stack.

[JJ]

@suntzu Glad to hear it worked !!!!

And you used pins 36 and 21 ?

Now I will have to order some of these MQ-2 sensors !! Thank you for the tip.

If you are open to posting a link to your code or a screenshot when done, that would be interesting to see.

[Suntzu]

@JimiT Yes, I used Pin 36 and 21.

Absolutely, I will post the finish product and pictures in the Projects section.

[DrWino]

I am been able to read the ADC on pin 35. This corresponds to ADC1_CH7 BUT I cannot get ADC on pin 36 to work. I think this is ADC1-CH0. Anybody has any sample code ? Thanks.